Networks & InfrastructureFaaJuniper NetworksHewlett Packard EnterpriseL3harris Technologies

FAA suspends Juniper router installs after outage grounds 17,000 flights

The FAA has paused Juniper router installations after a device tied to an outage that cancelled 17,000-plus flights. HPE says the kit behaved exactly as configured.

3 min read

FAA now grounds HPE Juniper routersNetworks & Infrastructure
FAA now grounds HPE Juniper routersSonjavdK / pixabay

Why it matters

  • The FAA suspended Juniper router installations on November 17 after an outage cancelled more than 17,000 flights.
  • Transportation Secretary Sean Duffy said 68 routers had been installed successfully before the problematic 69th unit.
  • HPE maintains the device functioned as configured by the installer and did not fail.
  • Weekend reports said the device was a copper-to-fiber media converter being tested at an L3Harris lab in Florida.
  • The grounding was the longest since the September 11, 2001 attacks.

The story

The US Federal Aviation Administration has suspended installation of Juniper network routers across its national network, after a device associated with a nationwide outage forced more than 17,000 flight cancellations — the longest grounding of US air traffic since the attacks of September 11, 2001.

Transportation Secretary Sean Duffy announced the decision on Tuesday, November 17. He told reporters that the FAA's migration from Cisco to Juniper equipment had run without a hitch for a full year before this incident. The agency had successfully tested and installed 68 routers to date.

"This was the 69th, and 68 had gone really well," Duffy said. "This was the one that started to behave this way. So we thought it's only prudent to pause the use of these routers."

The router in question is the device blamed for Friday's outage. Weekend reports indicated it was undergoing tests at a Florida laboratory belonging to L3Harris Technologies, the defense contractor currently converting the legacy copper network behind the FAA Telecommunications Infrastructure (FTI) to fiber-optic connectivity.

What do the lab tests show so far?

According to CRN, those tests have not yet established whether the hardware was the definitive cause of the nationwide ground stop. The outlet, citing an unnamed source, reported that the equipment was in fact a copper-to-fiber media converter rather than a conventional router.

The same source added a telling technical detail. The broadcasting feature on the device should have been switched off during activation, because it was communicating with a large network of 20-year-old Cisco 600 Series routers. That interaction, the source suggested, is what crashed the system.

In other words, the failure may have come from the collision of new equipment with two decades of legacy infrastructure, rather than from a defective unit. The FTI modernization program that L3Harris is executing — replacing copper with fiber — is precisely the kind of project where such boundary devices sit between old and new worlds.

What is HPE's position?

Hewlett Packard Enterprise, which acquired Juniper, has rejected any suggestion that its hardware failed. In response to a request for comment, HPE pointed to remarks it had previously made to the media, stressing that the device functioned as it was configured by the installer and did not fail or act improperly.

That framing shifts attention from the hardware itself to the configuration process — effectively pointing toward the installation and testing procedures used when the device was brought into service. It is a distinction with commercial weight: a configuration error implicates operational practice, while a hardware fault would implicate the vendor.

Why did the pause come when it did?

The FAA's suspension landed on the same day that Democratic lawmakers pressed Duffy to halt Juniper installations. The political pressure gives the timing of the decision a second layer: the agency acted both after a visible operational failure and amid congressional demands for exactly that step.

For the networking industry, the episode is a reminder of the aviation sector's unusual exposure to infrastructure transitions. A single device activating with the wrong settings — in a network that still includes Cisco 600 Series routers deployed two decades ago — can cascade into a nationwide ground stop measured in tens of thousands of cancelled flights.

The immediate path forward depends on the L3Harris laboratory results in Florida. Until those tests determine whether the device was the definitive cause, the FAA's Juniper rollout stays paused, and HPE's argument that the installer's configuration is the real story remains the vendor's public line.

Also reported

Share this article:

« PreviousNext »

More from Elena Vasquez

Elena Vasquez

Show full bio

Market editor covering companies, deals and strategy in Carrier business, 5G and 6G, fiber and broadband at Telecom Gazette.

551 articles